ZORum

Advanced search  

News:

Tired of Facebook drama and haters? Join ZORum and help us reunite the community.

Pages: [1]   Go Down

Author Topic: 16v heater/cooling question  (Read 227 times)

Bad Goat

  • ZOR CLUB
  • Hero Member
  • *
  • Offline Offline
  • Posts: 716
  • Located in: Oregon
16v heater/cooling question
« on: October 27, 2018, 10:05:26 AM »

From what i can tell the Suzuki 16v 1.6 & 1.3 both have constant flow through the heater core.  However the samurai shuts flow off to the heater core, so there is no coolant circulating before the thermostat opens.

Do people just hook the heater core to the samurai like stock?  No issues with the lack of flow during warm up?
Logged

nagtrainer

  • Psychotic zuker
  • THG
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 7226
  • Located in: Eunice NM
  • I am the PING master
Re: 16v heater/cooling question
« Reply #1 on: October 27, 2018, 12:11:31 PM »

Yup, no issues... Need to pay attention to the radiator cap though. The 16V's run at 13-16psi. I did a lot of research on this when I went through over heat issues with my 2000 swift G13BB SOHC swap. the heads aren't very forgiving. good news you can buy new bare heads for under 400 plus shipping.
Logged
A tech link that has Suzuki factory manual information for a small donation is
http://www.acksfaq.com
Pages: [1]   Go Up