Suspension

 

 

ZOR "SUPPORT BRA"

For Suzuki 1986 to 1995 Soft Top and Tin Top lower windshield frames. This one piece bracket supports everything. Designed to hide those hairline cracks around the windshield wiper holes also covers those rusted out spots. The SUPPORT BRA can hold lights, CB whips and even your stock Samurai mirrors when you have the doors off. Each kit comes with self tapping screws for a quick install. Made of .180" steel and powdercoated with a "silver vein finish".


 

MOUNTING:
These are screw on (or pop rivet, if your inclined. Rivets not included) and shipped in a powdercoated finish only. The mirror holes are already tapped and supplied with short 5 x 80 mm metric allen mirror screws. Silvervein is a black and silver mixed color.

COST :

$79.95 Samurai Soft Top Support Bra. Shipping charge will be emailed to you after purchase. Part#1-200SBS

COST :

$93.95 Samurai Tin Top Support Bra. Shipping charge will be emailed to you after purchase. Part#1-201SBT

 

 

 

ZOR "Yoda Axle Trusses"

The ultimate protection for Toyota axles. Yodas are laser cut 1/8" cold rolled steel folded on a 100 ton press. Designed with the Superman "S" for the upper truss and the "ZOR" logo for the lower truss. Logos are on both sides. Some slight sanding or grinding may be reguired to fit on your Toyota axle housing.


 

MOUNTING:
These are weld on and shipped in raw steel condition only. If you need only one, no problem.

COST:

$19.95 Superman "S" Upper Truss. Shipping charge will be emailed to you after purchase. Part#3-203TATU

$19.95 "ZOR" logo Lower Truss. Shipping charge will be emailed to you after purchase. Part#3-204TATL

 

 

 

ZOR "CRABS"

The ultimate protection for the Suzuki thin dif covers. Crabs are laser cut 1/4" cold rolled steel folded on a 100 ton press. They were designed to allow openings for stock E-brake cables, brackets and brake lines. Some slight sanding or grinding may be reguired.


 

MOUNTING:
These are weld on and shipped in raw steel condition only. If you need only one, no problem.

COST:

$61.00 Samurai axle set (front & rear). Shipping charge will be emailed to you after purchase. Both front & rear crabs are Part#1-204CRF

$32.00 Front or Rear Samurai Crab. Shipping charge will be emailed to you after purchase. Please specify by Part# at time of purchase. Front Part#1-202CF, Rear Part#1-203CR

 

ZOR "ROCK BITER KIT"

For Samurai side panels protection. They are made with 3/16" cold rolled flat plate steel that is laser cut for close tolerances then folded on a 100 ton press. Heavily welded at the exterior seams. The ROCK BITERS are the strongest one piece side rail ever designed. They look sharp with or without the Samurai fender flares. Designed to fit around the factory plastic trim bracket so removal of that bracket is not necessary for a quick installation. A complete bolt kit is provided but welding is recommended.


 

MOUNTING:
These are shipped in a raw steel condition only.

COST:

$229.95 ZOR Rock Biters. Shipping charge will be emailed to you after purchase. Part#1-205RB