ZORum

ZORum Technical => ZOR Product Instructions/MY-Turbo Section => Topic started by: ZORoffice on July 17, 2017, 11:16:05 AM

Title: ZOR Super Snatch Instructions
Post by: ZORoffice on July 17, 2017, 11:16:05 AM
ZuksOffRoad 17/14 Bolt "Super Snatch" Transfercase Mounting System Instructions



We install TC in the cradle. We then install hip and rib. Do not over tighten the four 1/2" horizontal bolts. Stop so bolt head can still spin when nylock touched opposing tab. Rotate the rib towards the t-case.


Hammer in the wedge between the frame and lower rear t-case mount. Align hole for bolt clearance.


Lift cradle with forward hip aiming above the crossmember. Go far enough to swing the rear hip up and onto the rear wedge spacer.


Rotate hip out towards driver and hang on driver side mount.


Take breath, it will hang there.


Align holes
Square spacer goes under crossmember bolt head down threads up, thru crossmember, through front hip hole, washer, lock washer, nut.


Narrow spacer goes under the frame below the wedge, bolt head down, thread up, thru lock washer, thru washer, thru spacer, thru frame, thru wedge into threaded nut.


MY